Assembly settings
Anteriore
Front form
Rectangular
Rectangular
scegliere ...
Front bezel colour
Black
Black
scegliere ...
Front bezel material
Plastic
Plastic
scegliere ...
Front dimension
24 mm x 18 mm
24 mm x 18 mm
scegliere ...
Montaggio
Design
Raised
Raised
scegliere ...
Mounting type
Panel mounting
Panel mounting
scegliere ...
Mounting cut-out
Ø 16 mm
Ø 16 mm
scegliere ...
Caratteristiche meccaniche
Terminal
Plug-in terminal, 2.8 x 0.5 mm
Plug-in terminal, 2.8 x 0.5 mm
scegliere ...
Di più
Buzzer system
Electronic non-contacting buzzer with IC oscillator
Electronic non-contacting buzzer with IC oscillator
scegliere ...
Indietro
Il vostro prodotto:
Anteriore
- Front dimension:
- 24 mm x 18 mm
- Front form:
- Rectangular
- Front bezel colour:
- Black
- Front bezel material:
- Plastic
Montaggio
- Design:
- Raised
- Mounting cut-out:
- Ø 16 mm
- Mounting type:
- Panel mounting
Caratteristiche elettriche
- Operating Voltage and Current:
Typ. 10 VDC ... 26 VDC, ≤ 20mA
Caratteristiche meccaniche
- Terminal:
- Plug-in terminal, 2.8 x 0.5 mm
- Tightening torque:
- Fixing nut max. 0.5 Nm
- Weight:
- 0.009 kg
Caratteristiche acustiche
- Tone frequency:
- 2.1 kHz
- Sound pressure:
- 88dB (A) ±8dB at a distance of 0.1m
Condizioni ambientali
- IP Protection:
- IP40
- Operating temperature:
- – 25 °C … + 55 °C
- Storage temperature:
- – 40 °C … + 85 °C
Certificati
- Approbations:
- DNV
- Conformities:
- CE, UKCA, 2011 / 65 / EC (RoHS), 2014 / 35 / EU (LVD)
- REACH:
- REACH compliant
- RoHS:
- RoHS compliant
Di più
- Short Description:
- Actuator, Ø 16 mm, 24 mm x 18 mm, Rectangular, Black, Plastic, Plug-in terminal, 2.8 x 0.5 mm
- Housing colour:
- Black
- Housing material:
- Plastic
- Product attributes:
- Further information see Technical data
- Buzzer system:
- Electronic non-contacting buzzer with IC oscillator
- Wiring diagrams:
Recommended Protection Circuit: If the buzzer is not indirectly protected against surge impulses by an EMC-compliant power supply or if the cable length exceeds 30 m, additional protection measures are recommended. In this case, a bidirectional TVS diode should be installed between the connection wires as close to the buzzer as possible, as shown in the schematic above. To suppress conducted emissions, a ceramic capacitor of 3.3 µF / 50 V should additionally be connected at the buzzer terminals [a] and [b].
A = Continuous tone
B = Interval tone 2Hz- Mounting cut-outs:
- Dimension drawings:
Scarica i file
Aggiungi al carrello