Indicator full-face illumination, Series 04, Ø 29 mm, Raised, IP65, Screw terminal

To obtain IP67, use marking plate Part Nr. 704.608.X

The switches comply with the “Standards for low-voltage switching devices” DIN EN 60947-1

The switches comply with the “Standards for low-voltage switching devices” DIN EN 60947-1/DIN EN 60947-5-1

Max. wire cross-section 2 mm x 2.5 mm²

Skinning wire 10 mm

Max. wire cross-section of stranded cable 2 x 1.5 mm²

use stranded wires only with wire end ferrules of 10 mm length

Only one polarity is allowed on each side when wiring.

Max. 300 m/s², pulse width 11 ms (sinusoidal EN IEC 60068-2-27)

Max. 100 m / s² from 10 Hz ... 500 Hz, (sinusoidal EN IEC 60068-2-6)

Relative humidity, max. 95%, non-condensing

When using the lamp block, the application guidelines must be observed.

A suitable LED remover Part No. 700.006.0

The luminous intensity stated is for when used with DC

Electrical and optical data are measured at 25 °C

The specified 72 and 110 VAC/VDC versions are built with a bridge rectifier

The specified 72 and 110 VAC/VDC versions are built with a protection diode

In case one LED fails, the other pair of still functioning LED›s is working. The light output then is half in order to indicate the malfunction and shows this way the need for replacement

Luminosity and wave length variations caused by LED manufacturing processes may cause slight differences regarding the illumination. The customer has to decide what resistor shall be used to the LED