Indicator full-face illumination, Series 04, Ø 29 mm, Raised, IP65, Screw terminal

To obtain IP67, use marking plate Part Nr. 704.608.X

The switches comply with the “Standards for low-voltage switching devices” DIN EN 60947-1

The switches comply with the “Standards for low-voltage switching devices” DIN EN 60947-1/DIN EN 60947-5-1

Max. wire cross-section 2 mm x 2.5 mm²

Skinning wire 10 mm

Max. wire cross-section of stranded cable 2 x 1.5 mm²

use stranded wires only with wire end ferrules of 10 mm length

Only one polarity is allowed on each side when wiring.

Max. 300 m/s², pulse width 11 ms (sinusoidal EN IEC 60068-2-27)

Max. 100 m / s² from 10 Hz ... 500 Hz, (sinusoidal EN IEC 60068-2-6)

Relative humidity, max. 95%, non-condensing

When using the lamp block, the application guidelines must be observed.

The max. overall length of the lamp may not exeed 25mm

The specified 6 V DC, 24 V DC Bi-colour; 130 V AC, 130 V DC and 230 V AC versions are built with a protection diode

The specified 130 VAC types are developed to run on a supply voltage of 130 VAC only

An operation at a higher supply voltage using commercial lampholders with integrated resistors, is not approved

If the 24VDC Bi-colour lamp is driven with normal polarity (plus on middle contact of the lamp) the first mentioned colour will light up, with inverted polarity the second colour will ligth up

The luminous intensity stated is for when used with DC

Electrical and optical data are measured at 25 °C

Luminosity and wave length variations caused by LED manufacturing processes may cause slight differences regarding the illumination. The customer has to decide what resistor shall be used to the LED